STRINGA-LEVEL™
www.MarkeIndustries.com |
|||||||||||||||||
|
|
||||||||||||||||
|
|
|||||||||||||||||
|
DOWNLOAD/PRINT PDF INSTRUCTIONS WATCH SHORT INSTRUCTION VIDEO WATCH FULL INSTRUCTION VIDEO [approximate 10 minute download] |
|
1. Roughly
step off how
STRINGALEVEL
will
best fit your
particular
project (as in cornering, entering and exiting a radius, incorporating the use of rigid sections…etc.) 
2. Determine desired layout reference point and mark wall. 
3. Hold first section to mark and secure one end of STRINGA-LEVEL to wall using backerboard or drywall screws. The use of 1/4" washers is also recommended to prevent damage to screw slot edges. Extend piece making sure bubbles are in the level position and screw in opposite end. ((NOTE: Be sure not to over tighten screws. Just snug against wall is all that is necessary to hold STRINGA-LEVEL in place.) Finish by screwing the inner slots as needed. 
4. Interlock following sections by sliding the ends into one another and repeat the securing procedure. (If STRINGA-LEVEL does not configure perfectly to your situation, simply continue without interlocking.) 
5. Begin stacking your material. 
6. After material has set, unscrew STRINGA-LEVEL to remove. 7. Gently scrape and/or sponge clean to ensure years of continuous service.
|